Haunt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
338 Posts
How I have seen it done...

Was like this, a small piece of rubber/plastic tubing, the length of the sword/knife (found at any home depot/Lowes) Tubing should end at the Mid point of the sword as this is where the "cut" on the actor is made. A bulb from a turkey baster ($3.00 at the grocery store). The bulb is hidden in the hand with the sword handle and then squeezed when near the actors neck. The tubing can be secured with clear packaging tape to the back side of the sword...

Thats my cheap and easy idea...

Melty
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top