Haunt Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
1,804 Posts
Discussion Starter · #1 ·
I should know better than to ever purchase Compaq components...they always seem to be proprietary. :(

I got this power supply a few days ago. Instead of the typical ATX pin-out it's got a couple of old style AT connectors and an on/off rocker switch. As you can see in the pictures, the wiring does not match the typical AT connectors. I've tried jumping every combination to get a Power Good signal so the supply will power up but nothing is working. I get a slight blip on the multimeter when the rocker is switched on but it dies right away. I'm open to any and all suggestions.


 

·
Registered
Joined
·
242 Posts
I have a couple of power supplies that I have had to "ground out" in order to work, all the rest (dozen or more) dont require anything, they just work.

Not sure why there is a difference.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top