Haunt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,420 Posts
Yeah Sickie I think your correct. After looking at the video again, it does look exactly as you said. Do you know where to get a hollow tombstone or is that something I should make myself? I assume she used one foam piece on the front with the design cut into it, and perhaps some other foam glued to the perimeter of the back for the void or space, and then simply added a piece of foam to the back to close it up. Any thoughts?
If you did the Toshiba tombstone persay, you could use that for the hollowed out part and put the light in there. Make sure its not one that gets too hot though, you would have a melted or fired up tombstone in no time.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top