Haunt Forum banner

1 - 4 of 4 Posts

·
Hillbilly Wrangler
Joined
·
3,472 Posts
Discussion Starter #1
okay so i went out and purchased a dremel router attachment and some router bits (expensive, why i dont know couldnt find them as individuals) I am having trouble with it to say the least. Im not sure if i should have just gone with the router table for my husbands router and used those kind of bits. They have more selections, its cheaper, but i already had the dremel and its lightweight. Im worried about doing many passes over a section to make it larger. the dremel bits are quite small and if im trying to make an epitaph or something like that then im worried about recking it once its done once. Also, do i cover the whole tombstone with putty or just the areas that i want to blend together. at 20 a sheet i dont like to waste thats why im practicing on my white leftover stryofoam. PLEASE...let me her how to work this thing im dying.
 

·
Registered
Joined
·
71 Posts
Howdy Turtle2778!

I just started using my Dremel & router attachment on the gravestone that I'm working on now. The 1st thing I did was practice on scrap material so I wouldn't bugger up my expensive pink foam board. Different depth settings, freehand vs. guided by the attachment, different bits. Once I got the feel of it, I went to work.

I had different sized areas and different depths to route, and I learned a few little things that might help you.

Work in a consistent pattern, so you don't have to jump around. Plan ahead to do intricate/detailed routing last. Mark the areas that you want to route carefully and clearly--learned that one the hard way. :) Don't switch back and forth between router bit depths; do all areas of one depth then switch to the other depth.

Be aware the speed setting of your Dremel and the speed @ which you move the Dremel/router attachment. I set mine at "2" and moved it at about 4" per 10 seconds. Your results may vary :) Anyway, the point is to route out the areas without melting the foam (too high a speed or moving too slow) or tearing up the foam (too low a speed or moving too fast).

Do your inscription last. That way, the base of the router attachment won't be moving over your inscribed lettering and potentially buggering it up. Personally, I'm not comfortable with doing lettering with the router, but that's just me :) I guess if you use a large squared simple font you could route lettering successfully...

And remember this: there are few things that you can mess up that cannot be fixed. If you accidentally route a little area that you shouldn't have, fill it with wood putty/spackling/wood filler, let it dry, and cut/sand as needed to disguise the "uh oh." I don't know if you can route over puttied areas, so repairs might best be done by hand...

HTH!
 

·
Registered
Joined
·
4,949 Posts
I love my Dremel but onlt for the little stuff dont expect to much from it for larger work or agressive work.

Same for the rotozip great for cutting shapes but better suited for lager router type work where the space is limited and free hand is needed.

routersare for the big work where a templet or guide can be used just be patient and take your time. I really like the dremel wand for freehand work.

That is just my humble opinion. I use all three tools on a regular
 
1 - 4 of 4 Posts
Top