Haunt Forum banner

Electronically Challenged Question

2K views 7 replies 5 participants last post by  SkeletalRemains 
I'm still new to the prop1 myself, but my first attempt at using one was a success due to the excellent support at efx-tek. I have a couple pics of my disassembled pop-up using the prop1 and the RC-4 and two 110vac air valves. The setup was pretty simple wiring it together took less than an hour. The prop1 was connected to a mat switch when triggered the cylinder extended for five seconds and the air horn blasted for one second. It also had a delay to keep the prop from triggering again for 90 seconds. For wiring info you can't beat the diagrams at efx-tek for their simplistic detail( unlike my pics with wires going every direction:) ). I put this in a trash can at the end of the drive and placed the mat off to the side of the drive as well. Most of the TOTs didn't trigger it their parents did and the TOTs too reluctant to enter the yard. I will most defiantly be using more prop1s in the future.

http://i141.photobucket.com/albums/r72/festivus5/DSCF0006.jpg
http://i141.photobucket.com/albums/r72/festivus5/DSCF0009.jpg
http://i141.photobucket.com/albums/r72/festivus5/DSCF0011.jpg
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top