Haunt Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3,921 Posts
Discussion Starter · #1 ·
I'll be adhering pink foam board to 1/8 hardboard. The hardboard is very smooth and shiny on one side, and more rough and a bit "textured" on the other. What side would be best to glue the foam to? I'm thinking the unfinished side but would like opinions before I do this.
TIA
 

·
Registered
Joined
·
3,921 Posts
Discussion Starter · #3 ·
I am going to use liquid nails, but I'm wondering if one side of the hardboard would be better than the other to glue the foam to.
 

·
Registered
Joined
·
3,921 Posts
Discussion Starter · #6 ·
Don't need to paint it. The foam board will be a stone castle wall facade across the drive way. 2x4 frames are built and awaiting the hardboard, followed by the foam. Once the foam is secure, I need to draw and route the grout lines with a dremel (hence the dremel thread;) ). I figured the rougher side but wanted some affirmation. Thanks!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top