Haunt Forum banner

Help on power supply

1433 Views 6 Replies 3 Participants Last post by  Otaku
I got my hands on 2 Boris talking skulls. One,is wired for a transformer and has a jack to adapt to an outside sound feed. The other is powered by 6 AA batteries and has a Microbone.

I am electronically challenged ,but I think I can adapt the Microbone to an adaptor for using outside sound.

I have never learned or tried doing anything electronic so adapting the power supply by making my own circuit board scares the boo out of me.

While I was looking at the set up I wondered.....AND HERE IS MY QUESTION FOR ALL YOU ELECTRONIC WIZARDS>>>>:confused:

Can I take the in and out wires off the battery pack and just put a 9 volt adaptor to accept a transformer and use the eletonics already installed in the skull to operate it?

This seems like it would work but I do not want to fry the unit if I can help it.
Any advice would be really appreciated. Thanks!:D
1 - 1 of 7 Posts
Hey spoke,

Sorry to be a party pooper, but what Otaku said just will NOT work. I know this is hard to hear, but I speak the truth.

So now all you have left is to pack up those Boris skulls and send them to me. I will dispose of them properly.

Just kidding.

Great find, been looking for these ( at a reasonable price) since they have been off the market. The electronics in this are pretty straightforward. Take a video when you get it finished.

*Secretly lusting over your skulls*
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.