Haunt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
487 Posts
I'm not sure what type of load your putting on this, but the ucrrent draw of theis motor at 12 VDC with no load is 10mA (milliamps). I'm guessing you plan on using this for a FCG. If the load reamins fairly light, such as a FCG, a 12 VDC 1000 mA walwart should work just fine.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top