Haunt Forum banner

Parallax servo controller -install?

2106 Views 7 Replies 5 Participants Last post by  buckaneerbabe
As you will soon see I know less than zero about installing software. My question is this; I have one servo installed in my skelly head and before I install the next I would like to check to make sure everything is ok with the
1st one. I have read the parallax servo controller manuel and it says to install the PSCI software. Is this necessary since i'm planning on using my VSA from Brookshire or is that something seperate that I also need to install?
1 - 1 of 8 Posts
the software from Parallax doesnt need to be installed it is kinda the same thing as VSA. You can use the psc "as is" with VSA.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.