Haunt Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
841 Posts
Discussion Starter #1
What do I use to power a 90 vdc motor-:confused: Dayton 4z728A?:confused:
 

·
Registered
Joined
·
41 Posts
I tried loooking at surpluscenter.com but the only 115:90VDC power supplies that had could only handle 2Amps. which that motor probably runs at at that even if it doesn't once under load it MOST likely does. Finding a power supply to handle it would probably cost more then the motor itself.
 

·
Registered
Joined
·
41 Posts
you might be ok with what i found check surpluscenter.com and look under DC power supplies. the one i found uses an 8 pin relay socket. Hope this helps some.
 
1 - 7 of 7 Posts
Top