We use the Colorsplash jr's with VSA at our haunt without a rapu....The setting we use are as follows:
set the dmx address to 44
Light #1 set to binary 44 or in some cases switch 10 is on to allow dmx control.
1 2 3 4 5 6 7 8 9 10 switches ( off is up and on is down position)
0 0 1 1 0 1 0 0 0 1 (44)
Then setup your tracks in VSA starting with track 44.
44 is (strobe) set start position 0 to 254
45 is (red) set start 0 - 254
46 is (green) set start 0 - 254
47 is (blue) set start 0 - 254
set all of these for "type"(dmx dimmer)
nerver having used a rapu for dmx I am not sure what port setting you need.
set the dmx address to 44
Light #1 set to binary 44 or in some cases switch 10 is on to allow dmx control.
1 2 3 4 5 6 7 8 9 10 switches ( off is up and on is down position)
0 0 1 1 0 1 0 0 0 1 (44)
Then setup your tracks in VSA starting with track 44.
44 is (strobe) set start position 0 to 254
45 is (red) set start 0 - 254
46 is (green) set start 0 - 254
47 is (blue) set start 0 - 254
set all of these for "type"(dmx dimmer)
nerver having used a rapu for dmx I am not sure what port setting you need.
